![]() Insert a floppy disk into your computer, and double click on the boot disk file you have just downloaded. To create a Windows 98 boot disk simply download Ms Windows 98 Boot Disk file at There are various way to create such boot up disk.īack to Top Creating Windows 98 Boot disk Commonly DOS is used as the start up operating system though there is an increasing trend to use linux OS. Most system rescue will start from a bootup floppy.īasically, a bootup floppy disk is just a floppy formatted with the minimal essence of an operating system. With the bootup floppy, we could now bypass the corrupted operating system in hard disk and trouble shoot in the boot up environment from the floppy disk. ![]() Fortunately ImageDisk will handle many different formatting types and even 8″ drives, so most disk formats can be done with the software with the exception of a few like that used on C64 disks.A bootup or startup floppy disk is the most common tool when comes to troubleshooting problems such as a system error or a bootup problem in hard disk due to a virus infection, damaged partition table, corrupted system files and other logical failures. ![]() It also pretty much only works on disks that are compatible with the IBM PC drives. It did surprise me however how many of my disks I thought were bad, are in fact actually sound media wise but just needed to be low-level formatted. So when a sector of a disks surface is genuinely bad this won’t magically fix the disk for you. These techniques have all worked for me, but they only really fix bad formatting on an otherwise good disk. The downside is ImageDisk doesn’t check for bad sectors during the format and is not filesystem aware so you should run Scandisk or the equivalent for the system used. It may be prudent to erase the disk before hand if the new format is different to the original on disk. In the process of writing the image the software also formats the disk. It does work most of the time however and performs the operation in the fewest steps.įinally the method I prefer is to create an image of an empty disk in the format you desire, and then writing that image to as many disks as you desire. I had mixed success with this as sometimes the format program didn’t always do a good job. The second method you can use is to completely erase the disk using ImageDisks erase function then format the disk normally on the system you wish to use it for. Unfortunately this doesn’t write a file system. This is useful in the case that you have to format a disk for a system that uses an exotic system, like C/PM systems for instance. ImageDisk has the function to format disks directly, but you have to know all the parameters for the disk format you’re using (or planning to). There are a few different ways to go about doing this. I found with ImageDisk I was able to redo the low level format of the disks. Normally with software provided in DOS (or windows for that matter) even re-formatting the disk would not fix this issue with the disk even if the magnetic media is in good shape. My drive was behaving badly at one point and thought there were bad sectors at random points, due to the heads not being clean and connectors to the drive control board being dirty. In the process I was formatting and checking the alignment of the disk using software called ImageDisk by David Dunfield. Yesterday I re-aligned my old 5.25″ floppy disk drive from our old computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |